Natupol Booster

Application

• Natupol Booster hives can be placed 4-7 days before the crop starts flowering
• Distribute the Natupol Boosters evenly throughout the plot. The best position is on a horizontal platform just above the ground
• Wait for at least 30 minutes after positioning the hives before opening the flight holes, this allows the bumblebees to calm down
• Open the ventilation openings in the top of the hive during warm weather
• Remove the white cap before opening the hive
• Pollination performance and duration varies per crop and depends on environmental conditions. Always consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation

Environmental conditions

Natupol Booster performs best at ambient temperatures between 12-30°C. Pay attention to advice for best practice in hot environments. Provide protection against direct sunlight.

Storage time after receipt

To guarantee the best pollination results, start using the hive on the day of arrival. If necessary hives can be stored for maximum 1 day.

Storage temperature

15–25°C.

Storage conditions

Keep hives in a well ventilated environment, out of direct sunlight.

Hygiene

Remove bumblebee hives after flowering of the crop and no later than 10 weeks after introduction.

Disposal

After the pollination cycle, once there is no life in the bumblebee colonies, the ‘Beehome’ system should be closed. Remove the plastic liner and the sugar water tank from the hive, then place the liner back inside. Seal the entire hive in a plastic bag, remove it from the crop area, and dispose of the sealed bag and sugar water tank in accordance with local waste disposal regulations.