Natupol Smart

Application

• Place the hive on a horizontal platform (avoid inclination, otherwise sugar water may leak)
• Position the hive about 20-60 cm above the ground in the shade of the crop or if necessary provide additional shading
• Under short day conditions (<10 hours light) position the hive near the top of plants, in such a way that the hive is exposed to the first daylight
• Wait for at least 15 minutes after positioning the hive before opening the hive entrance, this allows the bumblebees to calm down
• Pull the white sliding door of the hive upward until two openings become visible (entrance and exit). Do not remove the small grey door under the lid
• Pollination performance and duration varies per crop and depends on environmental conditions. Always consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation

Environmental conditions

Natupol Smart performs best at ambient temperatures between 12-30°C. Pay attention to advice for best practice under conditions with artificial light or in hot environments.

Storage time after receipt

To guarantee the best pollination results, start using the hive on the day of arrival. If necessary hives can be stored for maximum 1 day.

Storage temperature

15–25°C.

Storage conditions

Keep hives in a well ventilated environment, out of direct sunlight.

Hygiene

• Never move a hive from one greenhouse to another
• Remove bumblebee hives the latest 10 weeks after introduction
• Clean the hive stand before placing new hives

Disposal

After the pollination cycle, once there is no life in the bumblebee colonies, the ‘Beehome’ system should be closed. Remove the plastic liner and the sugar water tank from the hive, then place the liner back inside. Seal the entire hive in a plastic bag, remove it from the crop area, and dispose of the sealed bag and sugar water tank in accordance with local waste disposal regulations.