Presentation
Make sure that the Rollertraps are at least at room temperature before placing them. The glue will be softer and the traps will unroll more easily.
Horiver Rollertrap
Testimonials
Downloads
-
For trapping flying insects
-
Especially for areas where high pest pressure is expected
- Jump to:
- Use for
- Product details
- Directions for use
Use for
For trapping whiteflies, thrips, leaf miner and fungus gnats in hot spots or places where high pressure can be expected, such as along gables, ventilation windows and (other) draughty places.
Pests
Whitefly, thrips, leaf miners, fungus gnats.
"The general conditions of Koppert (Koppert B.V. and/or of its affiliated companies) apply. Only use products that are permitted in your country/state and crop. Always comply with the conditions specified in local product registrations. Koppert cannot be held liable for unauthorized use. Koppert is not liable for any loss of quality if the product is stored for longer than recommended and/or under incorrect conditions."
Product details
Mode of action
Insect pests are attracted to the colour of the sticky trap and get caught in the glue.
Product specifications
Presentation
Polyethylene ribbon coated with wet sticky glue.
Available colours and sizes
Colours:
yellow, blue, white, red, black and transparent
Standard sizes:
5, 15 and 30 cm x 100 m
15 cm width is also available in lengths of 125, 150 and 500 m; other lengths on request
Directions for use
Application
- Place Horiver Rollertraps in areas where high pest pressure is expected, such as along gables, near ventilation windows and at (other) places with dry conditions
- Rollertrap should be hung above the crop when the crop is still low
- Attach the Rollertrap to crop wires, greenhouse poles, or other supporting structures
- Place the Rollertrap approximately 25 cm above the crop, except for the 30 cm width which needs to be placed 40 cm above the crop
- To assist with placement, insert a rod or other expedient through the center opening of the roll which will allow the Rollertrap to spin freely while unrolling
- At the beginning and end of each run, cut the trap approximately 40 cm longer than the support structure. Wrap the extra around the support and secure with staples or clips. It may be necessary to secure the Rollertrap mid run to provide additional support.
- It is recommended to replace the Rollertrap after 10 months, or earlier if the surface is largely covered by insects and/or debris
- For additional recommendations and rates, contact your local Koppert representative or distributor
Dosage
One Rollertrap per 1 to 3 plant rows.
Timing
In high crops Rollertraps should preferably be installed when the crop is still low, just before or after planting.
Storage time
See Best before date.
Storage temperature
0-32°C/32-104°F.
Storage conditions
In a cool, dry place.
