Natupol Trio

Application

• Natupol Trio hives can be placed 4-7 days before the crop flowers
• Position the Natupol Trio hives evenly througout the plot. The best position is on a horizontal platform just above the ground
• Wait at least for half an hour after placing the hives before opening the flight holes, this allows the bumblebees to calm down
• Protect the hives from direct sunlight and rain, and weigh down the hive for example with a stone, to prevent it from blowing away
• Open the ventilation openings on top of the hive during warm weather
• Pull the white sliding door of each hive upward until two openings become visible (entrance and exit). Do not remove the small grey door under the lid
• Pollination performance and duration varies per crop and depends on environmental conditions. Always consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation

Environmental conditions

Natupol Trio performs best at ambient temperatures of between 12-30°C (keep out of sun on days with temperatures above 25°C).

Storage time after receipt

To guarantee the best pollination results, start using the hive on the day of arrival. If necessary hives can be stored for maximum 1 day.

Storage temperature

15–25°C.

Storage conditions

Keep hives in a well ventilated environment, out of direct sunlight.

Hygiene

Remove bumblebee hives after flowering of the crop and no later than 12 weeks after introduction.

Disposal

After the pollination cycle, once there is no life in the bumblebee colonies, the ‘Beehome’ system should be closed. Remove the plastic liner and the sugar water tank from the hive, then place the liner back inside. Seal the entire hive in a plastic bag, remove it from the crop area, and dispose of the sealed bag and sugar water tank in accordance with local waste disposal regulations.