Natupol Sprint

Application

• Place the hive on a horizontal platform (avoid inclination, otherwise sugar water may leak)
• Position the hive about 20-60 cm above the ground in the shade of the crop or if necessary provide additional shading
• Under short day conditions (<10 hours light) position the hive near the top of plants, in such a way that the hive is exposed to the first daylight
• Wait for at least 15 minutes after positioning the hive before opening the hive entrance, this allows the bumblebees to calm down
• Pull the white sliding door of the hive upward until two openings become visible (entrance and exit). Do not remove the small black door under the lid
• The lifespan of the hive is up to 4 weeks
• Pollination performance and duration varies per crop and depends on environmental conditions. Always consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation

Environmental conditions

Natupol Sprint is the best solution for temperatures above 30°C.

Storage time after receipt

Natupol Sprint hives should not be stored for any period of time. To ensure the best pollination results, the producer should start using the hive immediately on the same day it is received.

Hygiene

• Never move a hive from one greenhouse to another
• Remove bumblebee hives the latest 10 weeks after introduction
• Clean the hive stand before placing new hives

Disposal

After the pollination cycle, once there is no life in the bumblebee colonies, the ‘Beehome’ system should be closed. Remove the plastic liner and the sugar water tank from the hive, then place the liner back inside. Seal the entire hive in a plastic bag, remove it from the crop area, and dispose of the sealed bag and sugar water tank in accordance with local waste disposal regulations.